The following are the proper steps to follow when wiring your house, courtesy of casino games.
- Disconnect power
Power disconnection is the first step to do before trying any electric wiring in your home. Ask the power company put off the service to your house or disconnect just from the meter on the wall or side of your house. Ensure it is off before starting any work.
- Design a writing diagram
Design a wiring diagram which shows the location of the breaker box and the path of the wires to each outlet.
- Install conduits
Start by running the longest wires first to avoid wastage conduits in walls even if you don’t anticipate using them right away. Start each wire upstairs and pull it through to the basement. This way, you do not use a ladder to push the wire up between floors. You should also leave at least one foot of extra wire at each end just in case you need to move things around later.
- Get familiar with the different wires.
Make sure you understand which colored wire should go and its purpose to avoid electrical shock and ensure wiring your house is safe. When installing wires, you need to recognize the parts of the cables for wiring, the non-metallic electrical cable: the outer sheathing (the jacket) and the inner ones.
- Know outlet count
Determine how many outlets and switches will run on one circuit. Normally, six outlets per a 110-voltage circuit is advisable in a living area, while as few as two per circuit are the standard in a kitchen, where appliances use more wattage.
- Drill wire holes
Before drilling any holes, make sure you know what is on the other side of the wall/floor to avoid drilling through any electrical wires, ductwork, or water pipes. Proceed by drilling holes with a 1-inch bit in the middle of the studs where your wires will travel. The more outlets you have, the safer your home and you’ll be able to play games from Australia safely without interruption.
- Set a breaker
Set your breaker box where you can easily access it in the future. A location in a basement or a utility room is desirable.
- Pull the wires to the outlets
When wiring your house place the roll of wire next to the breaker box and pull the wire according to your diagram to the closest outlet or switch for each circuit. You can also run the wires straight through the box. Any wires sticking out of the box may just get dry walled over or could get cut from the electrical box. Use wire strippers to remove the outer plastic coating from the ends of the wires and attach them, according to the instructions on the box, at each outlet, fixture or switch.
- Install the circuits
Install individual circuits for each wiring set. The circuits must match the amperage of the wire and the intended purpose of the outlet.
- Check Your Work
Before closing up and calling it done, check your work! Pull on the connections to ensure they are safe. Switch on the power and make sure everything is correctly done and starts up without incident. Also, inspect the casings with a voltage tester to ensure they are not electrified. Deploy the right insulators also for longer life. Wiring your house is not an impossible task but you need to consult a professional to ensure that all regulations are met and to ensure that your safety which is ensured as well!
